VERIFIED SOLUTION i

Does MailStream Plus have the ability to post the entry point code to the output file if you are using the ADC PT, NDC PT or SCF PT parameters?

Does MailStream Plus have the ability to post the entry point code to the output file if you are using the ADC PT, NDC PT or SCF PT parameters?
 
1)
When using ADC PT, NDC PT or SCF PT parameters, the initial/original entry point code is always posted into the 6-byte E CODE location.  This is the initial entry point based on the first 3 digits of the ZIP Code, before EP MIN and/or EP ROL are applied if they are being used in the job. 

2)
Also, you can post the original entry point code using the POSTEI and put a location to post a value in position 8 – 10 for the Original entry point code.
** Note if the location is in the output file in a location above position 999, then post the output location in position 7 – 10.
*---+----1----+----2----+----3----+----4----+----5----+----6----+----7----+----8
POSTEI 123
POSTEI1234

 
If the job is using the EP ROL or EP MIN parameters, use the POSTEI and put a location to post a value in position 12 – 14 to post the “new” or final entry point code. 
** Note if the location is in the output file in a location above position 999, then post the output location in position 11 – 14.
 
*---+----1----+----2----+----3----+----4----+----5----+----6----+----7----+----8
POSTEI     567
POSTEI    5678
UPDATED:  April 21, 2017