VERIFIED SOLUTION i

How to install the Brother QL1050 printer on the Connect+ series and SendPro P series

Products affected: Connect+® 500W, Connect+® 1000, Connect+® 2000, Connect+® 3000, SendPro® P1000, SendPro® P1500, SendPro® P2000, SendPro® P3000
Watch this video or follow the steps after to install the Brother QL1050 printer.



Follow these steps to install the Brother QL1050 printer on the SendPro® P Series:
  1. Open the printer cover using the latches on the side of the printer and seat the roll in the printer. Close the cover.
  2. Connect the power cable to the power connector on the rear panel of the printer.
  3. Press the power button on the printer until the LED light comes on. It should be solid green.
  4. Connect the standard size USB cable to the USB port on the rear panel of the printer.
Note: There are two USB cables. One USB cable has a standard size connector on both ends of the cable. The other USB cable has a micro connector on one end of the cable and a standard size connector on the other end of the cable. The USB cable with the two standard size connectors connects the printer and the hub. The USB cable with the micro and standard size connectors connects the Connect+ and the hub.
  1. Connect the power cable to the power connector on the USB hub.
  2. Connect the standard size USB cable to one of the available standard size USB ports on the USB hub.
  3. Connect the micro USB cable to the micro USB ports on the USB hub.
  4. Connect the standard size USB cable to the Connect+.
Note: There is no need to install a printer driver on a Connect+.
UPDATED:  February 16, 2018