VERIFIED SOLUTION i
X

Setting up a wired LAN connection with SmartLink on the DM50/DM55, DM60 and DM100

UPDATED: 3 January 2019


To set up a SmartLink™ device with a wireless connection or an advanced LAN connection, such as a static IP address or custom DNS server, see the SmartLink Setup page and select Advanced Options.

Follow these steps to set up a basic LAN connection:
  1. Connect the SmartLink device to either a wall internet jack or router with the included network cable.
  2. Plug the power adapter into the SmartLink device and into a power outlet.
    • The SmartLink device’s lights will change colour.
    • Once the device is connected to the internet, the Network Connectivity light will blink green.
    • In addition, the SmartLink device’s Ethernet port lights will show green for successful connection status and yellow for network activity.
  1. Plug the USB cable into the SmartLink device and into the back of your meter.
    • The USB cable is the short cable.
    • The SmartLink device’s lights will again change colour.
    • Once a network connection had been established, the SmartLink device’s USB Connectivity light will turn green and its Network Connectivity light will blink green.
  1. Attach the SmartLink device to your meter with the included adhesive fastener strips (optional).

Note: If the network LED is not blinking green after 1 minute, visit the SmartLink troubleshooting page.

For further assistance, see how to Resolve issues with a SmartLink connection on the DM50/DM55, DM60 and DM100.

Environment Details

Products affected:
DM50™ / DM55™ (K721)
DM60™ (K722)
DM100i™ (P720)

Downloads

  • No Downloads