How to manually feed sets on the DF400

Learn how to manually feed sets on the DF400.

Products affected: DF400

It is possible to feed sets of 2 sheets of 20 lb. bond paper, either stapled or not. Such sets must be fed manually.

The maximum thickness of a set, including staple, cannot be more than (0.06").
A "D" fold cannot be done on multi-sheet sets.
If sets are stapled, ensure that the staple is parallel to the leading (top) edge, not vertical or at an angle (see illustration).

To manually feed sets:

Remove paper from the input feed tray before doing manual feeds.
Set the Output stacker tray to receive the folded paper.
Insert the paper into the manual feed slot until it hits the bottom.
To allow the folded page to have the address panel or top of printed page showing, paper should be loaded face up with the address edge going into the folder first.
Ensure that the paper is centered in the feed slot and falls between the side guides.
Press the Start/Stop button. The folder will feed and fold the paper.
When folded, the screen displays the message CHECK PAPER.
To fold more paper, repeat steps 2 through 6 until the job is finished.
Press the Reset button to return to the Ready screen.

UPDATED: August 14, 2021