How to calibrate a J696 label printer used with SendSuite Live, SendSuite Xpress, and more

Learn how to perform a quick or standard calibration on a J696 label printer used with SendSuite Live, SendSuite Xpress, Ascent SendSuite Arrival, and SendSuite Tracking.
Products affected: J696 printer, SendSuite® Live, SendSuite® Tracking, SendSuite® Arrival®, SendSuite® Xpress, Ascent™
Follow these steps to perform a quick calibration on a J696 printer:
  1. Confirm the printer is on and has media loaded.
  2. Press and hold the FEED button until at least one full label is output, then release the button and wait for the printer to process the data.
  3. One of the following calibration statuses will display:
  • CALIBRATION COMPLETE will be displayed if the calibration was successful. The media will advance to the top of next media.
  • CALIBRATION FAILED will be displayed if calibration was not successful.
  • WARNING LOW BACKING is a normal message when calibrating die-cut media mounted on a translucent liner or a notch tag stock media.
  1. If the calibration failed, press and hold the FEED button until the tops of two consecutive labels have been output.
  2. If CALIBRATION FAILED is displayed, perform a standard calibration.

Follow these steps to perform a standard calibration on a J696 printer:
 
Note: When calibrating a gap or reflective media, press and hold the FEED button until at least one label is output.
  1. Confirm the printer is on.
  2. Press the Menu button until you get to Media Settings.
  3. Press Enter.
  4. Use the Down button and scroll to Sensor Calibration.
  5. Press Enter to access the Sensor Calibration.
  6. Press the Down button to Perform Calibration.
  7. Press Enter.
  8. Press Yes to proceed.
  9. Proceed according to the following the media types:
  • Die-Cut: remove a label or two from the liner, then install the media, position the media sensor under the liner area, and press ESC.
  • Notched (or Reflective): install the media, then position the media sensor under a notch (or black mark), and press ESC.
  • Continuous: install the media, position the media sensor under the stock, and press ESC.
  • Scan Paper: use this for all media except Continuous, position label material (and liner, if any) over the sensor, and press ESC.
  • No media: press ESC.
  1. Confirm that the printer displays CALIBRATION COMPLETE.
  2. Press the ESC and then EXIT to return to READY.

UPDATED: August 14, 2021