How to install a card stock separator on your RISO ComColor

Products affected: RISO ComColor
Watch this video to learn how to install a card stock separator on your RISO ComColor.



Follow these steps to install the card stock separator:
  1. Remove any material
  2. Unlock the green side guide levers
  3. Open the side guides to the widest position
  4. Lower the lock lever on the left side of the separator
  5. Press the unlock lever on the right side of the separator
  6. Remove the separator
  7. Verify that the correct separator is being installed
NOTE: The card stock separator has a roller on top.
  1. Place the separator face down on the feed tray
  2. Slide the separator onto the arms and rotate it up until it locks in place
  3. Raise the lock lever on the left side of the separator
  4. Slide the paper thickness lever to the thick setting
UPDATED:  August 31, 2017