Troubleshooting "PB Commerce Cloud Not Found" with a wired connection on the SendPro C Lite, SendPro C, SendPro+, SendPro C Auto

Products affected: SendPro® C Lite, SendPro® C, SendPro®+, SendPro® C Auto (2H00, 8H00, 9H00)

Issue

The device displays the message "PB Commerce Cloud Not Found".

Cause

The device is unable to sync transaction data. This may be caused by problems with the network connection settings, the physical connections, or a firewall.

Resolution

UPDATED: June 1, 2020

First, determine the type of wired connection the device is using:

  1. Tap the Settings icon in the toolbar.
  2. Tap Wired.
  3. Check to see which connection type is selected.
    • If your connection type is DHCP, follow the steps below under DHCP.
    • If your connection type is Static IP, follow the steps below under Static IP.

DHCP

  1. Select DHCP.
  2. Tap Connect.
  3. If it does not connect, unplug the power cord and the network cable from the back of the device. The screen should turn off after 10 seconds.
  4. Wait 2 minutes.
  5. Plug the power cord and the network cable back in, ensuring that the power cord is plugged directly into a wall outlet and the network cable is plugged securely in the network port available on the back of the device.
  6. Quickly tap and release the power button to turn the device back on.
  7. Tap the Settings icon in the toolbar.
  8. Tap Wired (Ethernet) and make sure that DHCP is selected.
  9. Tap Connect.

Static IP

  1. Select Static IP.
  2. Make a note of the IP Address, Netmask, Gateway and DNS Address.
  3. Tap Connect.
  4. Scroll down to IP Address, Netmask, Gateway and DNS Address.
  5. Verify that all of the information entered in those fields is correct.
  6. Tap Connect.
  7. Remove the network cable from the back of the device.
  8. Tap the Connect button. The device will try to connect. Wait until the connection fails.
  9. Plug the network cable back into the back of the device.
  10. Delete the values in the IP Address, Netmask, Gateway, and DNS Address boxes.
  11. Enter the IP Address, Netmask, Gateway, and DNS Address that you noted in step 2.
  12. Tap Connect.
  13. Tap in the DNS Address box.
  14. Press backspace to delete the DNS address.
  15. Enter the DNS Address that you noted in step 2.
  16. Tap Connect.

If the device is still unable to connect, contact your IT department. Your network firewall may be blocking ports on addresses that are required for proper functioning of your device.

  • The device requires that the ports 80 (HTTP), 443 (HTTPS), 53 (DNS), 5938 (TeamViewer), 2300, and 8080 (OS updates) are not blocked.
  • Refer to the SendPro C Connectivity Guide for a complete list of addresses that need to be unblocked.

If you need further assistance, please use the Contact Us options below.