VERIFIED SOLUTION i

Troubleshooting envelope box fold on the DI900-DI950 and Relay 5000-8000

Products affected: Relay 5000, Relay 6000, Relay 7000, Relay 8000, DI900, DI950

Issue

When the envelopes are ejected from the inserter, the flaps have a box fold. That is, the flaps are folded over in a location other than the standard crease.

Cause

There are two possible causes for this issue:
  1. Material that is being inserted into the envelope is skewed or not entering the envelopes properly.
  2. When the inserter is trying to close the flap in the Trial Piece exit area, the measurement of the outer envelope is incorrect and the flap is being folded in a location other than the crease.

Resolution

UPDATED: 22 July 2019
To resolve this issue: 
  1. Remove any partially fed material from the feed trays.
  2. Open the front cover.
  3. Check for jams in the folder (area above knob 3).
  4. Closed all jam release knobs and covers.
  5. Press Cancel to clear the error.
  6. Press Clear Deck to remove any material that is still in the system. 
  7. Verify that the correct material is loaded for the job.
Note: To check the loading directions, select "Loading Directions and Pre-Run Adjustments" on the job screen.
 
If the issue is not resolved or if the issue returns,
contact customer support. Use the Contact Us options below.