Product Feature: DOC1GEN
Issue
Customer setup their logic to dynamically set the width of the Table Header "Contribution period" according to the number of columns displayed on the first row of Table Detail.
In particular, customer is using Condition logic to add Table Cells with certain Width IF the number of columns displayed on the first row of Table Detail exceeds a certain value.

Above logic works fine in Designer and PDF output. However, in Postscript output, the addition of Table Cells does not seem to work and would get the following output:

In above example, the Table Header of "Contribution Period" should expand until at least the right border of "XXX-S6" column.
In particular, customer is using Condition logic to add Table Cells with certain Width IF the number of columns displayed on the first row of Table Detail exceeds a certain value.
Above logic works fine in Designer and PDF output. However, in Postscript output, the addition of Table Cells does not seem to work and would get the following output:
In above example, the Table Header of "Contribution Period" should expand until at least the right border of "XXX-S6" column.
Cause
This is a DOC1GEN defect in early version of 5.6.
Resolution
UPDATED: November 2, 2017Issue is fixed since version v5.6.2655 of DOC1GEN.